Hiniker Snow&Ice Control

Salt & Sand Spreaders - 600 / 800 Series
Spread ice control materials quickly and easily with an efficient Hiniker Spreader. Snow removal contractors looking for additional profits will find them in ice control. Private users and municipalities will benefit from the labor saving efficiency of the wide 25 ft. spread pattern. And a big 1.45 or 1.78 yard capacity means you'll spend your time productively, rather than constantly reloading.


•	For full-size pickups or light-duty commercial trucks
•	Models 812/822: Big 8 ft. hopper with 1.78 cubic yard capacity—2.27 cubic yard with optional extensions
•	Models 612/622: 6 1/2 ft. hoppers fits full-size extended cab short-box pickups. Accommodates tool boxes in long box trucks
•	Convenient adjustable deflectors and internal baffles to customize spread patterns from 4 to 25 feet wide
•	Heavy-duty 12-gauge steel or 14-gauge stainless steel welded hopper
•	Briggs & Stratton Intek OHV engine with remote cab control panel for electric starter, throttle, and clutch systems

View Spreader Literature (PDF)
Download Spreader Literature (ZIP)


Optional 2 Piece Hinged Screens		Easily adjustable deflectors allow customized spread patterns up to 25 ft. wide		Also Available In 14 Gauge Stainless Steel

HOPPER: Constructed of 12-gauge steel or 14-gauge stainless steel formed and welded with continuous electric seam welding on the inside of hopper. The top edge is formed for rigidity. Side slope of 45 degrees allows smooth material flow. An adjustable self-locking feed gate with lever is standard.

GEAR CASE: The conveyor gear case has a cast aluminum housing. A precision-machined, hardened and ground steel worm gear drives a heavy-duty bronze spur gear. Both gears and bearing run in oil and are sealed from contaminants.

SPINNER: 12-gauge steel or 14-gauge stainless steel spinner chute assembly with two internal adjustable baffles and three external adjustable material deflectors provided to control spread pattern. Spinner disc is 11-gauge, 12-inch diameter with three welded fins. Spinner shaft of 1" diameter steel is mounted with sealed, self-aligning bearing.

CONVEYOR: Heavy-duty, self-cleaning, heat-treated pintle chain with 24,000 lb. tensile strength. Flight bars of 1/4" x 3/4" are located on 9 1/4-inch centers. The drive sprockets are six-tooth, self-cleaning type, mounted on 1-1/4" diameter steel shaft. Two screw-type adjusters are provided to take up chain slack.

CONVEYOR DRIVE: Briggs & Stratton Intek OHV air-cooled, single cylinder, four-cycle engine is mounted on the rear of the spreader. The engine is equipped with an air cleaner, 12V electric starter, and electric throttle control. An in-cab control panel has engine start, shut-off, throttle, and clutch control functions. A hinged engine hood fully encloses the engine. An electric clutch engages and disengages the drive sprocket. Power is transferred to the gear case through roller chain and sprockets.

OPTIONAL EQUIPMENT
•	Hopper Screens
•	Pickup Truck Tie Downs
•	12-inch Side Extensions
•	Adjustable Inverted "V"
•	Spinner Extension

Hiniker Spreaders Specifications

	LEVEL CAPACITY	LENGTH	HEIGHT	TOP WIDTH
Model 812/822	1.78 Cubic Yards	116" Overall	33 1⁄2"	54"
Model 612/622	1.45 Cubic Yards	98" Overall	33 1⁄2"	54"

We reserve the right to amend these specifcations at any time without notice. The only warranty applicable is our standard written warranty. We make no other warrant, expressed or implied.